Serial cables

Not all serial cables will work with all (or any) pen plotters, so make sure you’ve got the right cable before you decide your plotter is broken! Ideally you would want to get your plotter’s operation manual to see the schematics of the serial cable it expects. Unfortunately these are sometimes hard to find. If you are completely in the dark, try this cable. The schematics are here. We have successfully used this cable with the Roland DX series.


A 9 to 25 pin serial cable is usually what you need.

USB to Serial Adapters

In Windows, Chiplotle currently only supports COM ports to communicate with your plotter. On computers with real good-old RS-232 serial ports Chiplotle has no problem. Modern computers usually no longer have serial ports, so you need to use a USB to Serial interface to connect your plotter to your computer. Because Chiplotle only supports COM ports, what you need is a USB to Serial interface with drivers that supports VCP (Virtual COM Port), so that your USB to Serial interface shows up as a COM port. You may want to get USB to Serial interface with the FTDI Chip; it has VCP drivers and works well on Windows.

In OSX and Linux your USB to Serial interface will appear in your /dev directory as:


To find the correct device name you can simply list the /dev directory before and again after plugging in the interface. The new tty.XXX entries in the /dev directory are your serial ports.

For example, before plugging in the adapter:

douglas$ ls /dev/tty.*
/dev/tty.Bluetooth-Modem        /dev/tty.Bluetooth-PDA-Sync


douglas$ ls /dev/tty.*
/dev/tty.Bluetooth-Modem        /dev/tty.KeySerial1
/dev/tty.Bluetooth-PDA-Sync     /dev/tty.USA19Hfa14P1.1

So /dev/tty.KeySerial1 and /dev/tty.USA19Hfa14P1.1 are the new serials ports (in this case they’re actually the same serial port, /dev/tty.KeySerial1 is an alias added by the vendor for convenience).